Basic Assembly & Usage
Connect the Pipes: Screw the black suction pipes together and attach them to the bottom of the pump body.
Mount the Handle: Attach the crank handle to the center shaft of the green pump body.
Attach the Spout: Screw the U-shaped discharge spout into the outlet port (marked with an arrow for flow direction).
Secure to Drum: Slide the bung adapter onto the pipe, insert the pipe into the drum, and tighten the adapter into the drum’s threaded hole to stabilize the pump.
Note: Avoid using this pump with water-based liquids or corrosive chemicals (like acids or solvents) unless the manual explicitly states it is made of stainless steel or chemical-resistant plastic, as it may rust or degrade the seals.
Located at Mozart Bet Building First Floor Shop F25